How Can We Help?
Search for answers or browse our knowledge base.
-
Retro C
-
-
- Articles coming soon
-
- How to Replace the Retro C's Computer
- Configuring the Touchscreen Computer's "Power-On"
- How to Replace the microSD Card in a Display Computer
- How to Transfer Files to the Retro C
- How to replace the USB hard drive on the touch screen computer
- Set a Newer Computer’s BIOS to Power On
- Set an Older Computer’s BIOS to Power On
- Touchscreen Pointer Is Flipped or Mirrored
-
-
-
- Stuck Angle or Centerline - How to Recover & Recalibrate
- Replacing an Angle Encoder
- Angle Movements Overrun When Moving to Position
- Angle (Arch) Movements - Overview
- Angle Chains - Proper Chain Tension
- Diagnosing Unknown Noises Coming from Blade Motor
- Pivot Point Check
- Power or Wiring Troubleshooting for Angle Motors or VFDs
- Dirty Slide
-
- Stuck Angle or Centerline - How to Recover & Recalibrate
- How to Calibrate Centerlines 1–5
- How to Calibrate Centerlines 1–5 (Advanced)
- Centerline (Vertical) Movements - Overview
- Replacing a Centerline Encoder
- Replacing a Centerline Gearbox
- Checking the Centerline Maximum & Minimum (Max & Min) Height Setting
- How to Tighten the Centerline Slides
- How to Tension the Centerline Chains
-
-
- 3rd Scrap Drive Information (GS23 Only)
- Adjusting or Tightening the Scrap Conveyor Belt
- Configure the Scrap or Incline Conveyor to Always Run
- Replacing the Scrap Motor
- Scrap Belt - Support Roller Replacement
- Scrap Belt Sweeper
- Scrap-Belt Tracking and Alignment
- Retro C Scrap System Overview and Daily Checks
-
-
- VFD General
- Drive (VFD) Disconnected Warning: Diagnosis and Recovery
- GS1 & GS2
- GS20
- GS20 ACM/DCM Common Wiring
- GS20 Standard VFD Wiring Pictures, for all VFDs
- GS3
- Program a Replacement CFW Drive
- Troubleshooting an Overvoltage Warning on a VFD
- VFD Replacement Options
- Yaskawa V1000 Blade Programming
- How to: Program an Automation Direct GS23 VFD
-
-
- Common Retro C issues and solutions
- Countdown Timer Warning with All VC1s and VFDs Disconnected
- Scrap Belt or Scrap Incline VFD Disconnected: Troubleshooting
- Stuck Angle or Centerline - How to Recover & Recalibrate
- Touchscreen Pointer Is Flipped or Mirrored
- Troubleshooting: Encoder Unplugged Error
- Troubleshooting: The Stationary or Carriage Side Horizontals Won't Move Anymore
-
-
Linear Pickline
-
Plant One Projection
-
SmartConveyor
-
Sticker Printer
< All Topics
Print
Cable Layout Through the Stationary and Carriage Electrical Panels
Updated
The images below show where the cables enter the stationary and carriage sides of the machine. They are shown from inside the electrical panels. If you need to identify or replace a wire, these images can help.
Table of Contents