Help Center
-
Retro C
-
-
- Articles coming soon
-
-
-
- Angle (Arch) Movements - Overview
- Angle Chains - Proper Chain Tension
- Angle movements over run when going to position.
- Diagnosing Unknown Noises Coming from Blade Motor
- Power or Wiring Troubleshooting for Angle Motors or VFDs
- Replacing an Angle Encoder
- Stuck Angle or Centerline - How to Recover & Recalibrate
-
- Centerline (Vertical) Movements - Overview
- Checking the Centerline Maximum & Minimum (Max & Min) Height Setting
- How to set the "Minimum" position for Blade #5
- How to Tighten the Centerline Slides
- How To: Calibrate Centerline 1-5
- How To: Calibrate Centerline 1-5 (Advanced)
- How To: Tension The Centerline Chains
- Replacing a Centerline Encoder
- Replacing a Centerline Gearbox
- Stuck Angle or Centerline - How to Recover & Recalibrate
-
-
-
- Common Retro C issues and solutions
- Countdown Timer / E-Stop Troubleshooting
- Scrap Belt or Scrap Incline VFD Disconnected: Troubleshooting
- Stuck Angle or Centerline - How to Recover & Recalibrate
- Troubleshooting: Encoder Unplugged Error
- Troubleshooting: The Stationary or Carriage Side Horizontals Won't Move Anymore
-
-
Linear Pickline
-
Plant One Projection
-
SmartConveyor
-
Sticker Printer
< All Topics
Print
Linear Pickline – Lumber Kicker Examples
UpdatedJune 28, 2024
If your facilities’ Pickline needs to be set up to feed lumber from the left then you will need a kicker to be installed.
![](https://enventek.com/wp-content/uploads/2023/06/Reverse-Edgeline-graphic-1024x817.jpg)
![](https://enventek.com/wp-content/uploads/2023/06/20180418_140943-2-1024x768.jpg)
![](https://enventek.com/wp-content/uploads/2023/06/20180418_143409-1024x768.jpg)
![](https://enventek.com/wp-content/uploads/2023/06/20180426_134028-1024x576.jpg)
![](https://enventek.com/wp-content/uploads/2023/06/20180426_155946-1-1024x768.jpg)
![](https://enventek.com/wp-content/uploads/2023/06/20180426_160000-1024x768.jpg)
![](https://enventek.com/wp-content/uploads/2023/06/20180426_160015-1024x768.jpg)
![](https://enventek.com/wp-content/uploads/2023/06/20180426_160021-1024x768.jpg)
![](https://enventek.com/wp-content/uploads/2023/06/20180723_115703-1024x768.jpg)
![](https://enventek.com/wp-content/uploads/2023/06/20180723_115752-1024x768.jpg)
One customer custom fabricated and installed a perpendicular roller device that pushes the pieces against the edge line on the incline conveyor
![](https://enventek.com/wp-content/uploads/2023/06/perpendicular-roller-2021-01-28-1-1024x576.jpg)
Table of Contents