by Michael Bell | Sep 30, 2022 | Computer
Remove all of the cables, take a picture if needed so you can remember where they go. Don’t forget to remove the USB thumb drive. Remove the 4 silver screws on the left and right sides of the computer. You will need a 1/4” socket to remove, Remove the old...
by Michael Bell | Sep 30, 2022 | Carriage System
The Carriage encoder is located under a gray cover (see photo below) under the carriage on the lumber feed side of the saw. Carriage Encoder Location If you think the carriage encoder is bad and needs to be replaced follow these steps to replace it. Warning: Before...
by Michael Bell | Sep 29, 2022 | Material Feed System
The lumber guide wheel is the final point of adjustment for the lumber before it is cut. The guide wheels job is to position the lumber so that it is inline with saw blade 1 and 2. If you find that the lumber isn’t being cut at all (the wheel is pushing the...
by Michael Bell | Sep 29, 2022 | Scrap System
If the scrap belt is slipping on the roller or not staying centered manual adjustment is required. Step 1: Remove the gray chain guard so you have more room to work. There are two bolts on the right side of the cover that hold it in place. Once the bolts are removed...
by Michael Bell | Sep 28, 2022 | Troubleshooting
Common problems Out of Calibration (If power was lost in while saw was moving check all below)Length (Length of board is wrong)Centerline (Centerline of board is wrong)Angle (Angle of board is wrong)In Out (In out Conveyors are wrong position)Material Feed (Sync...