Help Center
-
Retro C
-
-
- Articles coming soon
-
-
-
- Angle and Centerline stalled motor due to jam.
- Centerline (Vertical) Movements - Overview
- Checking the Centerline Maximum & Minimum (Max & Min) Height Setting
- How to set the "Minimum" position for Blade #5
- How to Tighten the Centerline Slides
- Replacing a Centerline Encoder
- Replacing a Centerline Gearbox
-
-
-
Linear Pickline
-
Plant One Projection
- Articles coming soon
< All Topics
Print
Retro C: Encoder Locations
Updated
This image shows you where all the motors are located at on the Retro C. This is the same image that is printed and attached to the stationary side carriage door.

Table of Contents