by Michael Bell | Jul 27, 2023 | General
If a sensor malfunctions and is constantly sensing in the on or off position, you may need to simply “re-teach” the sensor. This is very easy to do and should take 5 minutes or less. The sensor diagnostics is under the Sensors tab. This is located in the...
by Michael Bell | Jul 26, 2023 | Computer, Plant One Projection, Software
Retro C Step 1: Locate the computer that runs your software. The Retro C’s computer is located in the touchscreen enclosure. Step 2: Turn off the computer or pi by pressing and holding the power button (has a blue light) on the top right side of the computer...
by Michael Bell | Feb 13, 2023 | Networking
Communication between drives, motors, and computers is all handled over cat5 ethernet cables. This page will go over some of the most common issues and how to troubleshoot them when they arise. First a little refresher: The Stationary Side The (Blue) wires connect...
by Michael Bell | Feb 6, 2023 | Blades
To replace a blade motor there are 9 steps Power down the entire saw Remove the saw blade Unwire the (2) airlines and unwire the power cables Remove the brake assembly Using a hoist or forklift as a hoist remove the old blade motor Attach the new blade motor Re-attach...
by Michael Bell | Jan 31, 2023 | VC1
Overview The replacement of a VC1 involves two main steps – Mechanical/Electrical and Software configuration. The Mechanical/Electrical steps entail removing and replacing wires and mounting the new VC1 into the machine. The subsequent step involves configuring...