by Michael Bell | Feb 7, 2023 | Centerlines
It is very rare that a gearbox will go bad but if that does happen or you are upgrading to one of our newer 100-1 gearboxes this article will instruct you on how to replace yours. Step 1: Remove Blade or Blades (OPTIONAL) We recommend removing the blade or blades that...
by Michael Bell | Feb 6, 2023 | Blades
To replace a blade motor there are 9 steps Power down the entire saw Remove the saw blade Unwire the (2) airlines and unwire the power cables Remove the brake assembly Using a hoist or forklift as a hoist remove the old blade motor Attach the new blade motor Re-attach...
by Michael Bell | Jan 31, 2023 | VC1
Overview: there are four steps that need to be done Write down the MAC addresses of the VC1 you are removing and the VC1 you are replacing. (Print the sheet provided) Unscrew the wires that are connected to the bad VC1 Remove the bad VC1 Put...
by Michael Bell | Jan 23, 2023 | Angles
Step 1: Remove the blue metal shroud that protects the angle encoder. There are (4) 9/16″ bolts that you will need to remove. Step 2: Inspect the encoder for anything that could cause the encoder to malfunction. One or both of the metal tabs/clips that hold the...
by Michael Bell | Sep 30, 2022 | Computer
Remove all of the cables, take a picture if needed so you can remember where they go. Don’t forget to remove the USB thumb drive. Remove the 4 silver screws on the left and right sides of the computer. You will need a 1/4” socket to remove, Remove the old...