Check the Centerline Maximum and Minimum Height Settings

Before You Begin

Safety: Stop the machine, follow the site lockout/tagout procedure, verify that hazardous energy is controlled, and release or secure stored mechanical and pneumatic energy before opening a panel, removing a guard, or adjusting components. Electrical work must be performed by a qualified technician.

When doing calibration on a saw head one of the things you will need to do is verify the max and min values. The Centerline moves up and down via a motor and chain and is only stopped because the motor mount bracket can’t move any more because it is stopped by the saw frame.

The “Max Position” – Note that the “Max Position” is reached when the gray mount bracket physically contacts/hits the saw frame (Blue).

The “Min Position” – Note that the “Min Position” is reached when the gray mount bracket physically contacts/hits the saw frame (Blue).

Confirm the Result

After restoring the machine through the approved startup procedure, confirm that the position or count changes in the correct direction, returns consistently, and reaches the commanded value without an encoder, calibration, or overrun warning.

If the issue remains, record the exact on-screen message, affected component, indicator-light state, and the last change made. Provide those details to Enventek Technical Support; do not repeatedly recalibrate or replace parts without identifying the cause.