by dalsond | Oct 9, 2023 | General
Encoder wire route The Conveyor encoder is located at the end of the shaft of the conveyor. The encoder wire travels through liquid tight to the conveyor panel and enters into the VC1. See below for the route of the encoder. The encoder may require replacement or the...
by Michael Bell | Aug 15, 2023 | Cart Puller, SpeedCatch
Please follow the step below to make sure that the encoder isn’t slipping Step 1: Remove the encoder’s protective cover Step 2: Check the set screw or collar (depending on which style encoder you have) and make sure they are not loose. Style 1: Style 2:...
by dalsond | Jul 27, 2023 | Electrical System
The encoders get wired to encoder blocks the connection. These blocks need the wires to be wired in a specific order.
by Michael Bell | Jan 23, 2023 | Angles
Step 1: Remove the blue metal shroud that protects the angle encoder. There are (4) 9/16″ bolts that you will need to remove. Step 2: Inspect the encoder for anything that could cause the encoder to malfunction. One or both of the metal tabs/clips that hold the...
by Michael Bell | Sep 30, 2022 | Carriage System
The Carriage encoder is located under a gray cover (see photo below) under the carriage on the lumber feed side of the saw. Carriage Encoder Location If you think the carriage encoder is bad and needs to be replaced follow these steps to replace it. Warning: Before...
