by Michael Bell | Sep 28, 2022 | Networking, Overviews
This document is provided to give you some general information about the saw’s internal network. Network Diagram The internal network is 10.1.1.1/24 IP Addresses Note: Not all IP addresses are in use. Some devices are optional and may not be installed. 10.1.1.1...
by Michael Bell | Sep 20, 2022 | Overviews
The Pneumatic system consists of all of the air-actuated valves. The blade brakes – all 5 contain air cylinders for safety during an e-stop event. The Lumber Stops – Both sides use air brakes. The Carriage – Moving the Carriage ut air brakes. The...
by Michael Bell | Jun 1, 2022 | Overviews
This image shows you where all the motors are located at on the Retro C. This is the same image that is printed and attached to the stationary side carriage door.
by Michael Bell | Jun 1, 2022 | Overviews
Motor Locations This image shows you where all the motors are located on the Retro C. This is the same image that is printed and attached to the stationary side carriage door.