Retro C Encoder Locations

Before You Begin

Safety: Stop the machine, follow the site lockout/tagout procedure, verify that hazardous energy is controlled, and release or secure stored mechanical and pneumatic energy before opening a panel, removing a guard, or adjusting components. Electrical work must be performed by a qualified technician.

This image shows where all the encoders are located on the Retro C. The same image is printed and attached to the stationary-side carriage door.

Confirm the Result

After restoring the machine through the approved startup procedure, confirm that the position or count changes in the correct direction, returns consistently, and reaches the commanded value without an encoder, calibration, or overrun warning.

If the issue remains, record the exact on-screen message, affected component, indicator-light state, and the last change made. Provide those details to Enventek Technical Support; do not repeatedly recalibrate or replace parts without identifying the cause.

Related Articles

• replace the carriage encoder
• replace an angle encoder
• replace a centerline encoder
• replace a material feed encoder
• replace a horizontal encoder