by Michael Bell | Jul 11, 2024 | Centerlines
NOTE: This article is only relevant for saws with our newer centerline chain drive system. This article is not meant for saws with the older “Joyce Actuator” centerline drives. Step 1: Using the saw software, go down near the minimum position, then raise...
by Michael Bell | Oct 23, 2023 | Centerlines
There are a number of reasons you might need to recalibrate your centerline. The most common reasons are: Older Retro C saws use screw drive centerlines that tended to fade down more often than our newer chain drive systems. Loss of power while the saw head was...
by Michael Bell | Oct 23, 2023 | Centerlines
There are a number of reasons you might need to recalibrate your centerline. The most common reasons are Older Retro C saws use screw drive centerlines that tended to fade down more than our latest chain drive systems. Loss of power while the saw head was moving....
by Michael Bell | Jul 13, 2023 | Angles, Centerlines, Troubleshooting
At times the Centerline and or Angle motors will stall when trying to move to position. This typically occurs due to one or more of these reasons. Debris has gotten into the chain that drives these movements. Debris has gotten into the slide on either the angle or the...
by Michael Bell | Feb 7, 2023 | Centerlines
It is very rare that a gearbox will go bad but if that does happen or you are upgrading to one of our newer 100-1 gearboxes this article will instruct you on how to replace yours. Step 1: Remove Blade or Blades (OPTIONAL) We recommend removing the blade or blades that...