by Michael Bell | Oct 23, 2023 | Centerlines
There are a number of reasons you might need to recalibrate your centerline. The most common reasons are: Older Retro C saws use screw drive centerlines that tended to fade down more often than our newer chain drive systems. Loss of power while the saw head was...
by Michael Bell | Oct 23, 2023 | Centerlines
There are a number of reasons you might need to recalibrate your centerline. The most common reasons are Older Retro C saws use screw drive centerlines that tended to fade down more than our latest chain drive systems. Loss of power while the saw head was moving....
by Michael Bell | Jul 13, 2023 | Angles, Centerlines, Troubleshooting
At times the Centerline and or Angle motors will stall when trying to move to position. This typically occurs due to one or more of these reasons. Debris has gotten into the chain that drives these movements. Debris has gotten into the slide on either the angle or the...
by Michael Bell | Feb 1, 2023 | Centerlines
If you get the error “Stall: Centerline 5-v25” during a setup, it can be because blade 5 is hitting the end stop. One possible reason this could be occurring is that the saw is out of calibration and the minimum position (the lowest possible position the...
by Michael Bell | Sep 27, 2022 | Centerlines
When doing calibration on a saw head one of the things you will need to do is verify the max and min values. The Centerline moves up and down via a motor and chain and is only stopped because the motor mount bracket can’t move any more because it is stopped by the saw...
