by Michael Bell | Feb 6, 2024 | General
If you are having problems with the Linear Pickline not recognizing lumber as it goes past the sensors it could be because the encoder is NOT counting properly. Typical Symptom: The lumber picker picks lumber, puts it into the trough, and the pickline takes it away...
by Michael Bell | Jun 19, 2023 | Linear Pickline
If your facilities’ Pickline needs to be set up to feed lumber from the left then you will need a kicker to be installed. One customer custom fabricated and installed a perpendicular roller device that pushes the pieces against the edge line on the incline...
by dalsond | Mar 26, 2023 | General
The Linear Pickline has the ability to work with other types of saws from nearly any manufacturer through the implementation of an integrated sensor array. The Linear Pickline’s sensor array will detect if a board is removed from one or more of the sensors and...
by Michael Bell | Sep 19, 2022 | General
Linear Pickline Installation Requirements 1.Information needed by Enventek The following information needs to be emailed back to Enventek promptly so that the saw can be made to fit your specifications. What is the conveyor length needed to fit your layout? See...
by Michael Bell | Sep 19, 2022 | General
Install Ethernet to Serial “Brain Box “Step 1: Cut off the wall plug and strip the wires back. Step 2: Strip the wire and then wire it directly into the (+) and (-) terminals as shown in the image below. The wire that has white lettering/dashes goes to...