by Michael Bell | Jan 18, 2024 | Scrap System
The scrap system is typically comprised of two conveyors, the one in the belly of the saw, usually referred to as the “scrap conveyor”. The second conveyor is the “scrap incline” which is outside the saw on either the stationary or carriage...
by Michael Bell | Jun 19, 2023 | Linear Pickline
If your facilities’ Pickline needs to be set up to feed lumber from the left then you will need a kicker to be installed. One customer custom fabricated and installed a perpendicular roller device that pushes the pieces against the edge line on the incline...
by Michael Bell | Sep 28, 2022 | Networking, Overviews
This document is provided to give you some general information about the saw’s internal network. Network Diagram The internal network is 10.1.1.1/24 IP Addresses Note: Not all IP addresses are in use. Some devices are optional and may not be installed. 10.1.1.1...
by Michael Bell | Sep 27, 2022 | Centerlines
Centerlines are saw blade movements on the Y Axis (vertical movements – up & down). All Retro C component saws contain one of two versions depending on the generation of the saw. Version 1 is the Joyce Actuator which is an enclosure screw that moves up and...
by Michael Bell | Sep 27, 2022 | Angles
The Angles or Arches are the movements that pivot the blade motors to angle. That is done with a semi circular arch, 50-2 chain gearbox, motor and encoder. The gearbox for the angle movement is a hollow shaft gearbox with a shaft and sprocket to drive the number 50-2...
