269-815-4150 sales@enventek.com
How Can We Help?

Search for answers or browse our knowledge base.

Documentation | Demos | Support

< All Topics
Print

Conveyor Encoder V40

Encoder wire route

The Conveyor encoder is located at the end of the shaft of the conveyor. The encoder wire travels through liquid tight to the conveyor panel and enters into the VC1. See below for the route of the encoder. The encoder may require replacement or the cable.

Overview of Conveyor and saw
Encoder Cover
Removed Encoder Cover
Encoder slide on shaft

Slide The encoder on to the shaft and clamp it down with the socket cap bolt. Then add the screws back to the flanges to mount them.

Tighten encoder cap screw

The wiring enters into the conveyor electrical box and directly connects to the VC1 with a RJ45 connector.

Plug encoder into the vc1

Lights indicate that it is properly plugged in.

Table of Contents