by dalsond | Oct 9, 2023 | General
Encoder wire route The Conveyor encoder is located at the end of the shaft of the conveyor. The encoder wire travels through liquid tight to the conveyor panel and enters into the VC1. See below for the route of the encoder. The encoder may require replacement or the...
by Michael Bell | Aug 2, 2023 | Scrap System
Step 1: Go to the VFD that controls the Scrap Conveyor (DR30) or the Scrap Incline (DR31), both are located in the scrap enclosure and take the front plastic cover off. Use a single strand of ethernet wire (color doesn’t matter) to connect the “DCM”...
by Michael Bell | Jul 27, 2023 | General
If a sensor malfunctions and is constantly sensing in the on or off position, you may need to simply “re-teach” the sensor. This is very easy to do and should take 5 minutes or less. The sensor diagnostics is under the Sensors tab. This is located in the...
by dalsond | Jun 9, 2023 | General, General
The Front Conveyor sensor is utilized on both the SmartConveyor and the front conveyor of the Linear Pickline. Additionally this sensor is the same one as the Retro C entry sensor. To determine whether the sensor is turned on, check if both lights are illuminated....