Read More
Remove all of the cables, take a picture if needed so you can remember where they go. Don't forget to remove the USB thumb drive.
Read More
If you get the error "Stall: Centerline 5-v25" during a setup, it can be because blade 5 is hitting the end stop. One possible reason this could be occurring is that the saw is out of calibration and the minimum position (the lowest possible position the centerline can go before hitting the end stop) needs to be recalibrated.
Read More
The purpose of this article is to explain how to tighten the centerline slide enough so that vibration does not allow it to move during setup while allowing it to move during normal operation.
Read More