by Michael Bell | Sep 29, 2022 | Material Feed System
The lumber guide wheel is the final point of adjustment for the lumber before it is cut. The guide wheels job is to position the lumber so that it is inline with saw blade 1 and 2. If you find that the lumber isn’t being cut at all (the wheel is pushing the...
by Michael Bell | Sep 29, 2022 | Scrap System
If the scrap belt is slipping on the roller or not staying centered manual adjustment is required. Step 1: Remove the gray chain guard so you have more room to work. There are two bolts on the right side of the cover that hold it in place. Once the bolts are removed...
by Michael Bell | Sep 28, 2022 | Troubleshooting
Common problems Out of Calibration (If power was lost in while saw was moving check all below)Length (Length of board is wrong)Centerline (Centerline of board is wrong)Angle (Angle of board is wrong)In Out (In out Conveyors are wrong position)Material Feed (Sync...
by Michael Bell | Sep 28, 2022 | Networking, Overviews
This document is provided to give you some general information about the saw’s internal network. Network Diagram The internal network is 10.1.1.1/24 IP Addresses Note: Not all IP addresses are in use. Some devices are optional and may not be installed. 10.1.1.1...
by Michael Bell | Sep 27, 2022 | Software
Recalibrating the touchscreen on your Retro C is really easy to do and can be completed in less than 5 minutes. If you find that when you touch screen the cursor is off the steps outlined here can help tremendously. Video showing you exactly what to do STEP BY STEP...