269-815-4150 sales@enventek.com

Category - Troubleshooting

Troubleshooting: Drive Disconnected Warning

Drive is disconnect warning on the check screen. The normal cause for this is a blown fuse. Use the check screen to locate the drive that is an issue. IE Carriage DR28? Note: When the saw is in e-stop mode all of the drives will be turned off for safety. If this is the case do a continuity test on all of the fuses that go to that drive to verify which one is an issue. Replace the fuses and then disable e-stop. The drive should turn on and be enabled.
Read More

Troubleshooting: Encoder Unplugged Error

There are a few ways to diagnose the issue. Get a known working good cable and run it into the VC1 for the movement. Note: In order to know which vc1 it runs into the check screen will indicate it. The vc1’s are labeled V(Number) IE V12. They are the same in the electrical box.
Read More