by Michael Bell | Jan 23, 2023 | Angles
Step 1: Remove the blue metal shroud that protects the angle encoder. There are (4) 9/16″ bolts that you will need to remove. Step 2: Inspect the encoder for anything that could cause the encoder to malfunction. One or both of the metal tabs/clips that hold the...
by Michael Bell | Sep 30, 2022 | Computer
Remove all of the cables, take a picture if needed so you can remember where they go. Don’t forget to remove the USB thumb drive. Remove the 4 silver screws on the left and right sides of the computer. You will need a 1/4” socket to remove, Remove the old...
by Michael Bell | Sep 30, 2022 | Carriage System
The Carriage encoder is located under a gray cover (see photo below) under the carriage on the lumber feed side of the saw. Carriage Encoder Location If you think the carriage encoder is bad and needs to be replaced follow these steps to replace it. Warning: Before...
by Michael Bell | Sep 27, 2022 | Centerlines
The centerline encoder is the counter that tracks the position of the vertical movement. Warning: Before entering the saw make sure you have engaged the emergency stop with the key and take it with you as well. Always lock out, tag out the machine during maintenance...
by Michael Bell | Sep 26, 2022 | Blades
Supplies Needed Torque Wrench or Ratchet with 20ft lb. settingT40 TORX BIT Warning: Before entering the saw make sure you have engaged the emergency stop with the key and take it with you as well. Always lock out, tag out the machine during maintenance in accordance...
