The Carriage encoder is located under a gray cover (see photo below) under the carriage on the lumber feed side of the saw. If you think the carriage encoder is bad and needs to be replaced follow these steps to replace it.
Read More
This document will teach you how to replace the 3/4 shaft on a horizontal conveyor when after it has been bent due to lumber buildup or jams.
Read More
- Date: September 19, 2022
- By: dalsond
- Categories: Scrap System
Document explaining how to replace the scrap motor on the Retro C
Read More
- Date: September 19, 2022
- By: Michael Bell
- Categories: General
This article was designed to give you an overview of the Retro C installation requirements.
Read More
- Date: September 21, 2022
- By: Michael Bell
- Categories: Overviews
If you would like a downloadable copy of the Retro C schematics that shipped with the saw please call technical support at (269) 815-4150
Read More