by Michael Bell | Jun 9, 2023
Periodically checking the chain tension of your SmartConveyor(s) is normal and recommended. This article will go over the basics of how to adjust the tension and how to determine if it needs to be tightened or loosened Step 1: Is to assess the chain tension. If the...
by Michael Bell | Sep 29, 2022 | Scrap System
If the scrap belt is slipping on the roller or not staying centered manual adjustment is required. Step 1: Remove the gray chain guard so you have more room to work. There are two bolts on the right side of the cover that hold it in place. Once the bolts are removed...
by Michael Bell | Sep 19, 2022 | Horizontal Conveyors
Retro C Conveyor Shaft Assembly Procedure Step 1: shaft check shaft length according to sheet abovecheck shaft diameter according to sheet above Step 2: shaft clamp clamp shaft 10 inches from the right side in shaft clamp Step 3: right end sprocket A) insert right end...
by dalsond | Sep 18, 2022 | Material Feed System
The material feed chain tension should be adjusted so that the chain doesn’t bind up or hook something when backing up around the sprocket. Material Feed Arms We recommend that the chain should be tight enough that it can’t be lifted more than 1/4” above...
by dalsond | Aug 11, 2022 | Horizontal Conveyors
Tools Needed: Phillips Head Screwdriver, 3/8” Socket Wrench Time: 10 min People: 1 Step 1: Locate the rotary encoder on the rear of the saw that you need to replace. NOTE: There are two encoders, one for each side (even though only one is shown here). You will need to...
