- Date: February 6, 2023
- By: Michael Bell
- Categories: Blades
To replace a blade motor there are 9 steps
Power down the entire saw
Remove the saw blade
Unwire the (2) airlines and unwire the power cables
Remove the brake assembly
Using a hoist or forklift as a hoist remove the old blade motor
Attach the new blade motor
Re-attach the brake assembly
Re-wire the power cables and replace the (2) airlines
Attach the saw blade
Read More
- Date: September 27, 2022
- By: Michael Bell
- Categories: Centerlines
The centerline encoder is the counter that tracks the position of the vertical movement. The centerline encoder is located either on the end of the shaft for the (older) Joyce actuator style or on the end of the shaft of the gearbox (newer style) behind a gray cover.
Read More
- Date: September 26, 2022
- By: Michael Bell
- Categories: Blades
To replace the blade the steps are basically identical for all the blades. Reattach the blade to the saw with 3 screws (Blades 1,2,3,4). Blade number 5 gets (6) screws. Make sure the blade is attached with the teeth cutting toward the front of the saw (where the operator is standing). Put 3 screws into the three holes that are countersunk. The screw heads will NOT stick up past the plane of the blade if the correct 3 holes are chosen.
Read More
