Read More
Recalibrating the touchscreen on your Retro C is really easy to do and can be completed in less than 5 minutes. If you find that when you touch screen the cursor is off the steps outlined here can help tremendously.
Read More
This article will explain how to replace the wire and air hoses that run in the energy chain above the rear guard of the Retro C.
Read More

To replace a blade motor there are 9 steps
Power down the entire saw
Remove the saw blade
Unwire the (2) airlines and unwire the power cables
Remove the brake assembly
Using a hoist or forklift as a hoist remove the old blade motor
Attach the new blade motor
Re-attach the brake assembly
Re-wire the power cables and replace the (2) airlines
Attach the saw blade
Read More
The centerline encoder is the counter that tracks the position of the vertical movement. The centerline encoder is located either on the end of the shaft for the (older) Joyce actuator style or on the end of the shaft of the gearbox (newer style) behind a gray cover.
Read More