by Michael Bell | Jan 5, 2024 | VFD
On GS drives if you experience overvoltage check the voltage readout within the software of the VFD. It should be below 340V, anything over that and you will get this error. Step 1) Please call Enventek for recommendations. In the past we have: Recommended that you...
by Michael Bell | Sep 28, 2022 | Troubleshooting
Common problems Out of Calibration (If power was lost in while saw was moving check all below)Length (Length of board is wrong)Centerline (Centerline of board is wrong)Angle (Angle of board is wrong)In Out (In out Conveyors are wrong position)Material Feed (Sync...
by Michael Bell | Sep 21, 2022 | VFD
The main reason for a Drive disconnect would be. Power Wire between the VC1 and the VFD is disconnected Faulty or misconfigured VFD Faulty VC1 Power Check if there is power to the VFD (Drive) if there is no power then the check screen will show disconnected. Most of...
