by Michael Bell | Jul 11, 2023 | E-Stop, Troubleshooting
If you are experiencing an issue with your Retro C where the “Countdown Timer” warning won’t go away, look at your “Check” tab. If it looks like this and none of your Stationary or Carriage VC1s or VFDs are connected this is what you...
by Michael Bell | Feb 13, 2023 | Networking
Communication between drives, motors, and computers is all handled over cat5 ethernet cables. This page will go over some of the most common issues and how to troubleshoot them when they arise. First a little refresher: The Stationary Side The (Blue) wires connect...
by Michael Bell | Sep 28, 2022 | Troubleshooting
Common problems Out of Calibration (If power was lost in while saw was moving check all below)Length (Length of board is wrong)Centerline (Centerline of board is wrong)Angle (Angle of board is wrong)In Out (In out Conveyors are wrong position)Material Feed (Sync...
by Michael Bell | Sep 28, 2022 | Networking, Overviews
This document is provided to give you some general information about the saw’s internal network. Network Diagram The internal network is 10.1.1.1/24 IP Addresses Note: Not all IP addresses are in use. Some devices are optional and may not be installed. 10.1.1.1...