by dalsond | Sep 18, 2022 | Material Feed System
Location The material feed encoders are located inside the extended fan cover of the motor that runs the dogs through the saw. NOTE: The encoders work to synchronize the two sides of the Retro C. If the saw loses synchronization or stalls it could be something...
by dalsond | Aug 11, 2022 | Horizontal Conveyors
Tools Needed: Phillips Head Screwdriver, 3/8” Socket Wrench Time: 10 min People: 1 Step 1: Locate the rotary encoder on the rear of the saw that you need to replace. NOTE: There are two encoders, one for each side (even though only one is shown here). You will need to...
by Michael Bell | Jun 1, 2022 | Overviews
This image shows you where all the motors are located at on the Retro C. This is the same image that is printed and attached to the stationary side carriage door.
