by Michael Bell | Jun 13, 2023 | Troubleshooting
A customer called and stated that after hitting the E-Stop that both of the VFDs for the Scrap Incline & Scrap Belt were disconnected (Yellow). Steps Taken Restart VC1 – No Change Restart Saw – No Change Unplug the RJ11 jack from VFD 30 – No...
by Michael Bell | Sep 29, 2022 | Scrap System
If the scrap belt is slipping on the roller or not staying centered manual adjustment is required. Step 1: Remove the gray chain guard so you have more room to work. There are two bolts on the right side of the cover that hold it in place. Once the bolts are removed...
by Michael Bell | Sep 20, 2022 | Scrap System
Sweeper for the scrap belt The sweeper is located under the carriage side of the saw, it is a angled bracket with plastic on it. The sweeper’s purpose is to remove the dust from the inside of the belt before returns to the top side. Adjusting the sweeper is simple,...
by Michael Bell | Sep 20, 2022 | Scrap System
The scrap belt support rollers are located on the underside of the Retro C. Their function is to support the belt as it travels under the saw. Their are six rollers on every Retro C, replacing one is pretty simple. Remove the two cotter pins that are on each end of...
by Michael Bell | Sep 20, 2022 | Scrap System
Retro C: Scrap belt re-alignment Realignment of the scrap belt can be a tedious process. 1. Tension the belt down well. The belt should be snug on the top of the rollers on both ends. There shouldn’t be a gap lifting up. The tension bolts need to be fairly close to...
