by Michael Bell | Sep 28, 2022 | Troubleshooting
Common problems Out of Calibration (If power was lost in while saw was moving check all below)Length (Length of board is wrong)Centerline (Centerline of board is wrong)Angle (Angle of board is wrong)In Out (In out Conveyors are wrong position)Material Feed (Sync...
by Michael Bell | Sep 26, 2022 | Blades
Supplies Needed Torque Wrench or Ratchet with 20ft lb. settingT40 TORX BIT Warning: Before entering the saw make sure you have engaged the emergency stop with the key and take it with you as well. Always lock out, tag out the machine during maintenance in accordance...
by Michael Bell | Sep 20, 2022 | Misc
The Retro C is calibration is fairly simple. Calibration needs to only be done on movements that have issues. However a full software calibration can be done in approximately 15 minutes. To fully calibrate the saw you will need to complete all 7 steps in the...
by dalsond | Sep 18, 2022 | Material Feed System
The Retro C is equipped with sensors that are constantly detecting the position of the lumber as it is loaded onto the material feed arms. As lumber passes by the sensors they measure the position of the board on each side to make sure that the board is not crossed...
by dalsond | Jun 2, 2022 | General
Retro C Basic System Includes Autofeeding SmartConveyor 8-12ft (10 chain conveyor)1 full set of saw bladesScrap incline NOT included.(optional)1 year phone or internet technical support Retro C Physical Specifications 208V-240V three-phase 150A (single-phase available...