by dalsond | Jan 23, 2023 | Angles
Angles can overrun when moving to position due to a couple of reasons. An encoder that is partially connected and allows the movement to hunt and then eventually find the postion. Check the encoder for that movement. The movement gets stuck and builds up power trying...
by Michael Bell | Sep 27, 2022 | Centerlines
Centerlines are saw blade movements on the Y Axis (vertical movements – up & down). All Retro C component saws contain one of two versions depending on the generation of the saw. Version 1 is the Joyce Actuator which is an enclosure screw that moves up and...
by Michael Bell | Sep 27, 2022 | Angles
The Angles or Arches are the movements that pivot the blade motors to angle. That is done with a semi circular arch, 50-2 chain gearbox, motor and encoder. The gearbox for the angle movement is a hollow shaft gearbox with a shaft and sprocket to drive the number 50-2...
