by Michael Bell | Sep 19, 2022 | Material Feed System
Material Feed Chain Loss of Synchronization Issue Loss of synchronization between the left and right material feed chains can occur when there is a disproportional amount of load on the side or the other. STEPS TO DIAGNOSE THE ISSUE Check the load on the conveyors...
by dalsond | Sep 18, 2022 | Material Feed System
The material feed chain tension should be adjusted so that the chain doesn’t bind up or hook something when backing up around the sprocket. Material Feed Arms We recommend that the chain should be tight enough that it can’t be lifted more than 1/4” above...
by dalsond | Sep 18, 2022 | Material Feed System
Location The material feed encoders are located inside the extended fan cover of the motor that runs the dogs through the saw. NOTE: The encoders work to synchronize the two sides of the Retro C. If the saw loses synchronization or stalls it could be something...
by dalsond | Sep 18, 2022 | Material Feed System
Description The Material feed system is the conveyors that move the material through the saw. They have the custom 120 chains which support the material. They are synchronized by software so that there is not a mechanical connection between one side and the other of...
by dalsond | Aug 11, 2022 | Horizontal Conveyors
Tools Needed: Phillips Head Screwdriver, 3/8” Socket Wrench Time: 10 min People: 1 Step 1: Locate the rotary encoder on the rear of the saw that you need to replace. NOTE: There are two encoders, one for each side (even though only one is shown here). You will need to...
