by Michael Bell | Sep 20, 2022 | Blades
This article will discuss the steps you should take if you suspect one or more of your blades are out of alignment. Maybe you have “crashed” a blade or blades into a board or maybe one of the blades has become misaligned over time (not common). This...
by dalsond | Aug 11, 2022 | Carriage System
The Material feed conveyors which feed lumber through the saw must be parallel to each other. A way to check that is to take a piece of lumber an run it until the lumber enters the saw before the blades. Once in that location stop the saw and put a vertical mark on...