by Michael Bell | Oct 6, 2022 | Horizontal Conveyors, Troubleshooting
If you find that one or more of the horizontals don’t move in or out anymore you more than likely have one of two issues. Issue 1: Saw dust has built up in the Horizontals and is stopping the movement. Solution: Use compressed air to blow out the Horizontal...
by Michael Bell | Sep 30, 2022 | Carriage System
The Carriage encoder is located under a gray cover (see photo below) under the carriage on the lumber feed side of the saw. Carriage Encoder Location If you think the carriage encoder is bad and needs to be replaced follow these steps to replace it. Warning: Before...
by Michael Bell | Sep 20, 2022 | Carriage System
Retro C: Carriage Movements Stalling & or Hunting If you notice that the Retro C carriage is stalling or hunting around at the end of a movement here are the steps that to take to resolve this issue. Step 1: Clean dust from the GearRack Step 2: Confirm that the...
by dalsond | Aug 11, 2022 | Carriage System
Checking the saw alignment, while not difficult, needs to be done in the correct order to realign. If the carriage moves during the cutting process it means one of two things. Either the Carriage air brake is not holding or the material feed conveyors are not parallel...