by Michael Bell | Oct 23, 2023 | Centerlines
There are a number of reasons you might need to recalibrate your centerline. The most common reasons are: Older Retro C saws use screw drive centerlines that tended to fade down more often than our newer chain drive systems. Loss of power while the saw head was...
by Michael Bell | Oct 23, 2023 | Centerlines
There are a number of reasons you might need to recalibrate your centerline. The most common reasons are Older Retro C saws use screw drive centerlines that tended to fade down more than our latest chain drive systems. Loss of power while the saw head was moving....
by Michael Bell | Jul 13, 2023 | Angles, Centerlines, Troubleshooting
At times the Centerline and or Angle motors will stall when trying to move to position. This typically occurs due to one or more of these reasons. Debris has gotten into the chain that drives these movements. Debris has gotten into the slide on either the angle or the...
by Michael Bell | Sep 20, 2022 | Misc
The Retro C is calibration is fairly simple. Calibration needs to only be done on movements that have issues. However a full software calibration can be done in approximately 15 minutes. To fully calibrate the saw you will need to complete all 7 steps in the...