by Michael Bell | Jun 23, 2023 | Material Feed System
Here is an example of the 2×3 air cylinder that we currently put on all the saws.
by Michael Bell | Nov 21, 2022 | Brakes
Section 1: Tightening the Retro C’s Airbrake Step 1: Manually unlock the blade brakes in the “manual controls” section of the Retro C software. Step 2: Disconnect the air hose from the saw. Step 3: Verify that the saw has automatically engaged the...
by Michael Bell | Sep 28, 2022 | Troubleshooting
Common problems Out of Calibration (If power was lost in while saw was moving check all below)Length (Length of board is wrong)Centerline (Centerline of board is wrong)Angle (Angle of board is wrong)In Out (In out Conveyors are wrong position)Material Feed (Sync...
by Michael Bell | Sep 20, 2022 | Overviews
The Pneumatic system consists of all of the air-actuated valves. The blade brakes – all 5 contain air cylinders for safety during an e-stop event. The Lumber Stops – Both sides use air brakes. The Carriage – Moving the Carriage ut air brakes. The...
by Michael Bell | Sep 20, 2022 | Wiring
Replacing the wires and pneumatics that run in the energy chain. Required for installation. Heat Shrink gun (Hot air gun) Wire cutters Screwdriver Allen wrenches Possible tools Drill Step 1: POWER OFF THE SAW! Disconnect your air supply.Step 2: Find the end of the...
