by Michael Bell | Feb 1, 2023 | Centerlines
If you get the error “Stall: Centerline 5-v25” during a setup, it can be because blade 5 is hitting the end stop. One possible reason this could be occurring is that the saw is out of calibration and the minimum position (the lowest possible position the...
by Michael Bell | Sep 20, 2022 | Carriage System
Retro C: Carriage Movements Stalling & or Hunting If you notice that the Retro C carriage is stalling or hunting around at the end of a movement here are the steps that to take to resolve this issue. Step 1: Clean dust from the GearRack Step 2: Confirm that the...