by Michael Bell | Feb 6, 2024 | General
If you are having problems with the Linear Pickline not recognizing lumber as it goes past the sensors it could be because the encoder is NOT counting properly. Typical Symptom: The lumber picker picks lumber, puts it into the trough, and the pickline takes it away...
by Michael Bell | Sep 30, 2022 | Carriage System
The Carriage encoder is located under a gray cover (see photo below) under the carriage on the lumber feed side of the saw. Carriage Encoder Location If you think the carriage encoder is bad and needs to be replaced follow these steps to replace it. Warning: Before...