by Michael Bell | Jun 19, 2023 | General
Here is a great example of Pickline chain that is too loose: Here is what the pickline’s chain tension should look like: In the picture below you can see what a chain in need of tensioning looks like. The tension idler should be vertical (not horizontal)....
by Michael Bell | Jun 9, 2023
Periodically checking the chain tension of your SmartConveyor(s) is normal and recommended. This article will go over the basics of how to adjust the tension and how to determine if it needs to be tightened or loosened Step 1: Is to assess the chain tension. If the...
by Michael Bell | Jun 9, 2023 | Angles
The angle chain need to be periodically checked to maintain proper chain tension. Proper chain tension will allow it move slightly from side to side but not so much that it becomes floppy or is able to move significant amounts, conversely you don’t want it so...
by Michael Bell | Sep 20, 2022 | Wiring
Replacing the wires and pneumatics that run in the energy chain. Required for installation. Heat Shrink gun (Hot air gun) Wire cutters Screwdriver Allen wrenches Possible tools Drill Step 1: POWER OFF THE SAW! Disconnect your air supply.Step 2: Find the end of the...
by Michael Bell | Sep 19, 2022 | Material Feed System
Material Feed Chain Loss of Synchronization Issue Loss of synchronization between the left and right material feed chains can occur when there is a disproportional amount of load on the side or the other. STEPS TO DIAGNOSE THE ISSUE Check the load on the conveyors...